Hanna Env logo HannaEnv

Effluent SS Exceedance: Finding the Real Cause Before Doubling the Dose

Effluent SS Exceedance: Finding the Real Cause Before Doubling the Dose

Effluent suspended solids have only two ways to escape: bad settling or hydraulic carryover. This troubleshooting guide shows how SV30 separates the two cases, what to do about filamentous bulking, when clarifier-ahead coagulant aid is legitimate — and when the real problem is just an inaccurate dosing pump.

First question: settling problem or hydraulic carryover?

Run an SV30 before touching any dosing pump. If the 30-minute settled volume exceeds 90% and the interface barely drops, the sludge itself is not settling — almost always filamentous bulking or an overloaded biomass. If the SV30 is normal (20–40%) yet the clarifier still loses solids, the biology is fine and the problem is hydraulic: short-circuiting, a broken weir, rising sludge from denitrification bubbles, or simply too much flow for the clarifier surface area. The two cases need opposite responses, which is why a blanket dose increase so often achieves nothing.

If it is filamentous bulking: fix the cause, weight the floc

Filaments outcompete normal floc-formers when the nutrients are unbalanced (often nitrogen or phosphorus deficiency in industrial plants), when dissolved oxygen runs low, or when septic or sulfide-rich feed favors sulfur filaments. Correct the balance and the aeration first — that is the durable fix. As a chemical bridge, dosing polymeric ferric salts such as PFS or polyaluminium-ferric PAF adds weight and charge compression to the floc, suppressing the filaments' dominance in the short term; in acute cases controlled chlorination of the return sludge kills filaments selectively, but it must be dosed against a measured filament count, never as a habit.

Clarifier-ahead coagulant aid: a bridge, not a cure

When effluent SS must come down today, dosing PAC at 10–30 ppm with a trace of PAM at 0.2–1 ppm into the channel before the secondary clarifier captures fine colloids that the biology misses and visibly tightens the overflow. The flocculant dose is deliberately tiny — over the 1 ppm range you start reflocculating solids that were already settling. Treat this program as a bridge that buys compliance time while the root cause is fixed: it raises sludge production and chemical cost, and left on permanently it masks the real problem.

Check the hydraulics: weir loading and rise rate

Many "chemical" problems are flow problems. Verify the surface overflow rate against design — storm infiltration or an upstream pump station running flat out pushes the rise rate past what the floc can survive — and inspect the weir: uneven loading from a tilted or algae-blocked weir concentrates flow into one sector and drags solids over locally. Watch for denitrification rising (nitrogen bubbles lifting floc to the surface, signaled by a big gap between the nitrate value and the dissolved oxygen at the clarifier inlet) and for wind-driven surface currents in open tanks, both of which mimic settling failure but respond to neither coagulant nor polymer.

Verify the dosing equipment before raising anything

Before any dose increase is approved, answer three questions with measurements: is the metering pump actually delivering its set value (calibrate it against a drawdown cylinder), is the polymer stock at its intended concentration and age (an over-aged PAM solution loses most of its power), and is the injection point where you think it is (a strainer half-plugged with lumps changes the real dose hour by hour). A surprising share of "the chemical stopped working" cases end at a failed pump diaphragm or an unnoticed stock-tank makeup error — problems that a 30-minute audit finds, and that doubling the dose would merely have paid for.

Request a quotation

Send your product, quantity and destination port — you will receive an offer with specifications, packaging and lead time.